![]() He referred to problems that seemed to relate to a possible defective HDD. MintJulip had indicated that he/she had been experiencing problems with (apparently) three separate HDDs - each one containing an OS. When you use the Windows Disk Management snap-in tool to mark your primary partition as active, the computer may not start up if the partition marked as active does not contain the Windows boot files (or boot files for another operating system) Doing so will cause your computer to stop working. If all goes well you can subsequently connect the "old disk" as a secondary drive.ĭon't mark a partition as active if it doesn't contain the loader for an operating system. When you desire to boot to a different OS contained on that multi-partitioned HDD you will need to mark that partition "Active".ĥ. Hopefully you should be able to boot to the OS that you marked as "Active". Ensure that the HDD containing the three operating systems is connected to the first SATA connector on the motherboard (designated either SATA 0 or SATA 1).Ĥ. Shut down the PC and (temporarily) disconnect the "old disk". Ensure that the OS you desire to boot to has been selected by invoking the option "Mark Partition as Active".ģ. Connect that HDD as a secondary disk and access Disk Management. But we'll assume there's no problem there.Ģ. Disk (partition)-cloning operations go awry from time-to-time so it's always conceivable that for one reason or another the cloned data may be dysfunctional. First of all we've got to assume that the internally-connected HDD containing the three OSs each in a separate partition are (potentially) bootable/functional OSs. Question: How can I make the computer recognize the newly created single Disk with 3 OS in 3 partitions? My friend suggested that I probably need to change the MBR, but I don’t even know what that is and where it is located. ![]() I can then open and browse the newly cloned HDD with 3 partitions and 3 OS with all the data. However, when I plug it with one of my old HDD and press F9, the computer recognize the old disk and will launch from there. The problem is: when I plug the new internal HDD, the computer does not recognize it. I renamed the drive letters to match the old ones from the old HDD. ![]() I then cloned the one external HDD with 3 separate OS into one internal HDD of the same size. I was able to save all my data including the OS. I was able to successfully clone the 3 separate internal HDD with 3 separate OS and combine them into a new and single external HDD with 3 separate partitions. It has clicking sounds, high reallocated sector count, and hard to boot sometimes. I have 3 separate internal HDD with 3 different Windows OS on my old HP desktop that is starting to fail.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |